
Standing water out, drying started, insurance documented
Water extraction in Pacoima, California, done before the damage spreads
Water extraction in Pacoima, California, is the first hour that decides whether you replace a floor or a whole room. We pull standing water with truck-mount and portable units, meter the walls, and start drying the same visit. Whether a burst pipe flooded your kitchen on Van Nuys Boulevard or a toilet overflow soaked the hallway, our crew is on call 24/7 and works straight through. Call (833) 321-7153 and we roll.
What's included
What our water extraction service includes
Every water extraction job we run in Pacoima includes source identification, extraction, moisture mapping, drying setup, and documentation. Repairs like new drywall, flooring, and paint are quoted separately once the structure is dry and verified, so you are never paying for rebuild before we know what actually needs replacing.
Source identification
We find where the water is coming from before extraction starts. Thermal imaging camera, moisture meter, and bore scope map the wet zone inside walls and under floors. If it is a slab leak or burst pipe, we stop it first.
Standing water extraction
Truck-mount extraction units and wet vacuums pull water from carpet, pad, hardwood, tile, and low wall cavities. A sump pump handles deeper standing water. Most flooded floors yield 20 to 40 gallons in the first two to three hours.
Moisture mapping and logs
We log moisture readings room by room, photograph affected materials, and record daily drying progress. Those logs are what your insurance adjuster needs and what proves the structure is actually dry before rebuild starts.
Drying equipment setup
Industrial dehumidifiers, air movers, and desiccant units placed based on the moisture map. You get a written drying plan with equipment count and target days, usually three to five, plus daily monitoring visits.
Antimicrobial treatment
On contaminated water jobs like sewage backup or toilet overflow, we remove affected material and apply antimicrobial solution. Negative air machines keep spores and odor from spreading through the rest of the house while we work.
Verification and handoff
We verify dryness with a hygrometer against a dry standard, not by touch. Once readings pass, we hand off to repair with final moisture logs and photos for your file. Nothing gets closed out until the numbers say it is dry.
Service overview
What water extraction in Pacoima, California actually involves
Water extraction in Pacoima, California, is the mechanical removal of standing and trapped water from floors, walls, and cavities using wet vacuums, truck-mount extraction units, and sump pumps. It is not the same as drying. Extraction gets the bulk of the water out in the first few hours; drying then pulls the remaining moisture out of drywall, baseboard, and subflooring with industrial dehumidifiers and air movers. Skip extraction and you are drying a swimming pool. We extract first, then dry, then verify with a moisture meter before anything gets rebuilt.
Most calls we take in Pacoima start with the same handful of failures: a slab leak under a 1960s ranch home, a burst pipe behind a bathroom wall, a roof leak after a winter storm, or a sewage backup in a low bathroom. Water finds the path of least resistance, which usually means your subflooring and the bottom two feet of drywall. That is why we treat every job as a timer, not a to-do list. If you are searching for water extraction in Pacoima California near me at 2 a.m., you are exactly who we built the night crew for.
The service timeline
Our water extraction process, step by step
The process flexes to the condition, but these checkpoints keep decisions clear.
Call and triage
You call (833) 321-7153 and we ask three things: where is the water, is it clean or sewage, and is the source stopped. That tells us what to load. We give you an upfront price range on the phone and a real arrival window. Most Pacoima calls get a crew on site within 60 to 90 minutes.
Source and inspection
We find where the water is coming from before we pull a drop. A thermal imaging camera and a moisture meter map the wet zone, and a bore scope checks inside walls. If it is a slab leak or a burst pipe, we stop the water first. Extracting a live leak just means doing the job twice.
Extraction
Truck-mount units for volume, wet vacuums and a sump pump for the rest. Carpet, pad, hardwood, tile grout lines, and low wall cavities all get pulled. A typical flooded floor yields 20 to 40 gallons. This step usually takes one to three hours depending on square footage.
Drying setup
We place industrial dehumidifiers and air movers based on the moisture map, not a guess. Desiccant units go in when humidity is high. You get a written drying plan with equipment count and a target number of days, usually three to five. We check readings daily and adjust.
Verification and rebuild
We do not call a job dry because the floor feels dry. We verify with a hygrometer against a dry standard, then hand off to repair. Drywall, baseboard, and subflooring go back in code-correct. You get final moisture logs and photos for your file.
Tools & methods
Tools and methods we use
Purpose-built equipment, used by trained technicians, so the job is done accurately the first time.
Truck-mount water extraction unit
The workhorse for volume. Pulls 20 to 40 gallons from a flooded floor in the first couple of hours and keeps running while we set drying equipment.
Thermal imaging camera
Finds water inside walls and under floors that you cannot see or feel. This is how we locate a slab leak or a hidden wet cavity before it becomes mold.
Moisture meter and hygrometer
Reads moisture content in drywall, subflooring, and framing, and measures relative humidity in the air. We use both to set a dry standard and prove the job is finished.
Industrial dehumidifier and air mover
Drying equipment. Dehumidifiers pull moisture out of the air, air movers push it off wet surfaces. Together they dry a typical Pacoima room in three to five days.
Bore scope
A camera on a flexible line that lets us look inside a wall cavity without tearing it open. We use it to confirm whether insulation and framing are wet.
Sump pump and wet vacuum
For deeper standing water and tight spaces the truck-mount cannot reach, like a basement or crawl space. Pumps move volume, wet vacuums finish the surface.
Negative air machine
Creates negative pressure in a contained work zone on sewage and mold jobs so spores and odor do not migrate into the rest of your home.
Use cases
When to call for water extraction
These examples show how the service framework adapts rather than forcing every call through one repair.

Sewage backup in a Hansen Hills bathroom
A main line backup pushed Category 3 water through a downstairs bathroom and into the hallway carpet. The homeowner had mopped and run a box fan for two days before calling, and odor had spread through the first floor. → We removed the affected carpet, pad, and 24 inches of drywall, extracted the rest, applied antimicrobial solution, and ran a negative air machine for three days. Final readings passed, odor cleared, and the rebuild was finished in six days total.
Roof leak and ceiling stain near San Fernando Road
A winter storm pushed water through failed flashing on a flat roof. The ceiling showed a two-foot stain, and the attic insulation above it was saturated. The homeowner had already painted over the stain once, and it came back within a week. → We traced the entry point, extracted and dried the attic framing and insulation, and repaired the ceiling drywall and texture after readings passed. Drying took five days; the repair matched the existing texture and the stain has not returned.
Problems we solve
Water problems we solve for Pacoima homeowners
Most water damage we see in Pacoima comes from the same short list of failures. The fix is always the same: stop the source, get the water out fast, and dry the structure before mold gets a foothold.
Slab leak soaking the floor from underneath
We locate the leak with thermal imaging and a moisture meter, isolate the affected zone, extract the trapped water, and dry the slab and flooring from above. Then we repair the flooring and baseboard once readings are dry.
Burst pipe behind a bathroom or kitchen wall
We shut off the water, open the wall, extract standing water, and dry the cavity with air movers and a dehumidifier. Insulation gets replaced, drywall goes back, and we test the line before closing anything up.
Sewage backup in a low bathroom or laundry
We remove affected material, extract the rest, apply antimicrobial solution, and run negative air machines. This is a removal job, not a drying job, and we treat it that way from the first minute.
Roof leak after a winter storm
We trace the leak, extract and dry the attic framing and insulation, and repair the ceiling drywall and texture. If mold has already started, we handle attic mold remediation to ANSI/IICRC S520.
Pricing process
What water extraction costs in Pacoima
$350 - $1,200 for most residential jobs; $1,500 - $4,000+ for sewage or multi-room floods
Square footage affected
A single flooded room is a different job than a whole first floor. Extraction time and equipment count scale with square footage, and so does the price. Most single rooms land at the low end of the range.
Water category
Clean water from a supply line is straightforward. Category 3 water from sewage backup or toilet overflow requires material removal, antimicrobial solution, and negative air machines, which adds labor and disposal cost.
Material that must be removed
Carpet and pad almost always come out. Hardwood sometimes can be saved with mat drying. Drywall and insulation below the water line usually have to go. The more material removed, the higher the cost.
How much does water extraction cost in Pacoima California?
Most residential water extraction jobs in Pacoima run $350 to $1,200 in 2026, depending on square footage, water category, and how much material has to come out. A single flooded room with clean water sits at the low end. Sewage backup or a slab leak that soaked multiple rooms pushes higher. We give you an upfront range on the phone before we roll, and we document everything for your insurance claim.
How long does water removal take in Pacoima?
Extraction itself takes two to four hours on a typical flooded floor. The full dry-out takes three to five days with dehumidifiers and air movers running. We check moisture readings daily and do not pull equipment until your walls and subflooring hit a dry standard. Rushing that step is how people end up with mold three weeks later.
Is water extraction covered by insurance in Pacoima California?
Most sudden and accidental water damage is covered, including burst pipes, appliance leaks, and toilet overflow. Long-term seepage and foundation seepage are usually excluded. We photograph affected materials, log moisture readings, and build the scope in Xactimate so your adjuster has what they need. We work with all major carriers and can bill direct on most claims.
What equipment is used for water extraction in Pacoima?
We run truck-mount extraction units and wet vacuums for volume, a sump pump for standing water, and a moisture meter plus thermal imaging camera to map the wet zone. Drying uses industrial dehumidifiers, air movers, and desiccant units when humidity is high. Sewage jobs add a negative air machine and antimicrobial solution. Brands on our trucks include Dri-Eaz, Phoenix Restoration, RIDGID, and Milwaukee.
Ready when you are
Get water extraction in Pacoima, California, started now
Every hour of standing water means more torn-out drywall and a bigger bill. We are licensed, insured, IICRC-certified, and on call 24/7. Call (833) 321-7153 and we will give you an upfront range and a real arrival window before we roll a truck.

Talk with the local team
Request water extraction
Call (833) 321-7153 any time, day or night. Our dispatcher answers live and sends the closest crew, with most Pacoima addresses reached within 60 to 90 minutes. You can also email photos of the damage to info@waterdamagerestorationpacoima.com and we will call you back with next steps.


